Maintaining your heating and air-conditioning in Snellville, GA, is important to avoid major repairs and breakdowns in the height of the cooling or heating season. One of the best ways to do this is to have the system professionally inspected and tuned up twice a year. The spring is the best time to have the air conditioner looked over, but it’s also important to have an inspection in the fall before the furnace needs to be used. Here are some reasons fall maintenance is important and what should be done.
The main reason to have a fall checkup for your HVAC system is to reduce the number of problems you have throughout the winter. A large percentage of necessary repairs can be avoided during the winter simply by having a professional look at all the components of your heating system. Small problems that can worsen over time will be detected, which means you can get the minor repairs you need before they become more serious and result in a more expensive repair or even the total loss of heat when you need it most.
Safety is another important reason to have your furnace checked out every fall. Problems can arise once the furnace is in use that can result in carbon monoxide leaking into your home. This can, at the very least, make the home’s occupants ill, and in the worst case scenario, carbon monoxide poisoning is deadly. A regular checkup in the fall will ensure there aren’t any problems with leaking carbon monoxide.
You can also boost energy efficiency by having your furnace checked out by a professional. Dirty or damaged components can cause fuel to burn less efficiently and there may be airflow problems that could also negatively impact energy efficiency. Even a furnace with a high energy efficiency rating (AFLU percentage) can benefit from a regular tune-up. This is better for the environment and for your wallet as well.
Although it’s important to have professionals in HVAC in Snellville, GA, check out your system in the fall, there are some things you can do to improve efficiency and protect your system during the winter. Be sure to replace the air filter at least every three months. However, it’s a good idea to check it monthly to make sure it’s not dirty enough to be replaced more often than that. Clean the registers and vents to allow good airflow. You can reduce the amount of time your furnace runs by reversing ceiling fans to push warm air down into the room. Also, the most energy-efficient setting for your thermostat is 68 degrees. This will help extend the lifespan of your heating system.
A professional tune-up in the fall is important to boost efficiency and identify any problems. The technician will look for a number of things during this thorough inspection. The system will be tested to confirm the furnace starts and runs the full cycle as it should. Short cycling can indicate the need for one or more repairs. The filter and thermostat will both be checked, and the burners evaluated for proper ignition and combustion. All electrical connections and voltage will be assessed in addition to a carbon monoxide test. A thorough cleaning is another important task that will help your furnace run better. Contact Triad Mechanical today to schedule your fall furnace tune-up.
Year Founded: 1991
Lifetime Customer Satisfaction: 97%
BBB Rating: A+